Cagrilintide Reconstitution Calculator
A long-acting amylin analog studied alongside GLP-1 agonists in metabolic-research contexts. This page works out concentration, volume per measured amount, syringe units and preparations per vial for a reconstituted Cagrilintide preparation, plus the mass-to-molar conversions for its stated molecular weight. Everything runs in your browser; plan entries stay in this browser, with optional device-local saving and calendar export.
Also referenced as: AM833, NNC0174-0833
02 / Calculated draw
Arithmetic from your entries. Confirm the product, concentration and syringe with your pharmacist or clinician before administration.
- Concentration
- —
- Amount per administration
- —
- Volume per administration
- —
- U-100 syringe marking
- —
- Whole administrations per vial
- —
- Remainder per vial
- —
Enter the vial, water and administration amounts to calculate.
Syringe capacity
Whole administrations exclude dead space, handling losses and expiry. A calculated quantity is not a guarantee of usable supply. No rounding to a nearby syringe mark is performed.
Protocol schedule
Schedule an existing prescribed or approved protocol. This tool cannot determine how often you can safely take a peptide. Frequency, dose, reconstitution, storage and discard instructions must come from the product label and your clinician or pharmacist.
04 / Your calendar
Complete your calculation and timing to build a schedule.
Calculations stay in this browser. Saving is optional and device-local. Calendar export creates a file; import it into your calendar and configure reminders there. PeptiDex does not send notifications.
| Date & time | Amount | Draw | Vial |
|---|
Measurement reference: FDA guidance on concentration, syringe size and mg/mL/unit conversion errors.
A separate worked example, step by step
This separate arithmetic example uses a 5 mg vial, 2 mL of bacteriostatic water, and a 250 mcg target amount. They are not a property of Cagrilintide and not an amount anyone should draw — these figures only illustrate the arithmetic.
- Concentration. 5 mg ÷ 2 mL = 2.5 mg/mL (2,500 mcg/mL), which for Cagrilintide is approximately 0.6701 mM at its stated molecular weight.
- Per syringe unit. A U-100 syringe divides 1 mL into 100 units, so one unit holds 2,500 mcg ÷ 100 = 25 mcg.
- Volume for the 250 mcg target. 250 mcg ÷ 2,500 mcg/mL = 0.1 mL, or 10 units on that syringe.
- Preparations per vial. 5,000 mcg ÷ 250 mcg = 20 preparations.
Arithmetic on a laboratory preparation, shown as a unit-conversion reference. Not medical advice, not a dosing recommendation, not an instruction for human use. The full derivation, and why the diluent volume is a choice rather than a constant, is on the main reconstitution calculator.
Mass and molar equivalents for Cagrilintide
Derived from the molecular weight recorded on the Cagrilintide entry: ~3731 g/mol — the entry states this as an approximate figure, so the equivalents below are approximate too. Concentration in molar units is what an in-vitro protocol is usually specified in.
| Quantity | Molar equivalent |
|---|---|
| 1 mg of Cagrilintide | 268 nmol (0.268 µmol) |
| 1 mcg of Cagrilintide | 0.268 nmol |
| A 1 mg/mL solution | 0.268 mM (268 µM) |
Molar amount = mass ÷ molecular weight. Figures are shown to four significant digits and are a unit conversion, not a measurement.
Reconstitution recorded for Cagrilintide
Lyophilized powder typically reconstituted with bacteriostatic water; refrigerate and protect from light after reconstitution.
Quoted from the Cagrilintide entry. Amounts reported in the research literature for this compound are documented on that entry, under the disclaimer they belong with — they are not reproduced next to a calculator. Read the full Cagrilintide entry.
Handling questions for Cagrilintide
What documentation should be expected for research-grade cagrilintide?
A third-party COA with HPLC purity (commonly greater than or equal to 98%) and mass-spec identity confirmation is the standard reference. Lyophilized cagrilintide is stored cold and reconstituted with bacteriostatic water for research handling, avoiding light exposure and freeze-thaw cycles.
Answers are published on the Cagrilintide entry. Educational summaries of research-literature context, not medical advice.
Continue exploring
- Full Cagrilintide entry — Long-acting amylin receptor agonist (amylin analog)
- Reconstitution calculator — the maths in full, with a second worked example
- Storage & Handling guide
- Bacteriostatic water — what it is and how it differs from sterile water
- Compare Cagrilintide with another library entry